5.74 Regolazioni, Italiano
Regolazioni, Italiano 5.75
- Procedura di regolazione.
1. Regolazione centro orizzontale
2. Regolazione G2
3. Regolazione della messa a fuoco
4. Regolazione EFC
5. Regolazione 16:9
6. Regolazione 15:9
7. In modalità di servizio, “Format setting”
Geometry lock
: OFF
4:3
: YES
8. Regolazione 4:3
- Completamento della verifica della geometria e della relativa regolazione.
1. Pulire il tubo catodico
2. Pulire lo schermo di contrasto
3. Rimontare lo schermo di contrasto
Impostazioni iniziali per regolare il televisore
Non montare il pannello posteriore superiore prima di avere completato la
regolazione.
- Collegare la tensione di rete e accendere il televisore.
- Rimuovere le eventuali spine Scart collegate alle prese corrispondenti
Immettere SETUP e selezionare CONNECTIONS.
Impostare V.TAPE su V.TAPE.
Premere
GO
e quindi
EXIT
per uscire dal menu.
Per consentire l’accesso alla funzione Focus e al potenziometro G2 potrebbe
essere necessario estrarre parzialmente lo chassis principale dal telaio principale.
Regolazione centro orizzontale
L’interruttore centro orizzontale 5S1 deve essere regolato sulla posizione sinistra,
centro o destra. Vedere
1.
Premere
V.TAPE
.
Lo schermo diviene nero.
Verificare che il televisore sia in formato 3 (16:9), premere
LIST
(fino a FORMAT) +
3
.
Regolare il potenziometro G2, SCREEN, fino a quando lo sfondo risulti
chiaramente illuminato. Vedere
2.
Ridurre H-AM fino a far risultare l’immagine più piccola del telaio di circa 10 mm
per lato.
Accedere al menu Service
Menu – Setup - 0 0 GO - Geometry adjustment
Selezionare H-AM
GO.
Prendere nota del valore.
Effettuare la regolazione con 5S1 per una posizione centrale ottimale. Accertarsi
che l’interruttore si fermi allo scatto e non tra due posizioni.
Ripristinare il precedente valore di H-AM.
Premere
GO
per memorizzare il valore.
Premere
EXIT
per uscire dal menu.
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK