5.28 Einstellungen, Deutsch
Einstellungen, Deutsch 5.29
G2-Spannung
TV-Modus V.TAPE
Format
16:9, Format 3
Testbild
Schwarz bzw. keine Quelle angeschlossen.
Menüeinstellung
Picture – Brilliance 32, Colour 32, Contrast 44
Servicemenü-Einstellung
Nicht benutzt
- Messung mit einem Oszilloskop.
Oszilloskopmasse mit GROUND von PCB3 verbinden, siehe
3.
Spannung des Testimpulses an den Testpunkten R, G und B messen, siehe
3.
Messpunkt bei der höchsten Spannung wählen und G2 einstellen, bis der Impuls
145 ± 3V beträgt.
- Einstellung mit Multimeter (Ri > 1 M)
Multimeter auf Gleichspannungsmessbereich von mindestens 200 V einstellen.
Massekabel mit Masse an PCB 3 verbinden, siehe
3.
Spannung des Testimpulses an den Testpunkten R, G und B messen, siehe
3.
Messpunkt mit der höchsten Spannung feststellen und Messkabel hiermit verbinden.
Messpunkt bei der höchsten Spannung wählen und G2 einstellen, bis die Spannung
ca. 167 V beträgt.
Fokuseinstellung
TV-Modus V.TAPE
Format
16:9, Format 3
Testbild
Testbild 16:9
Menueinstellung
Picture – Brilliance 32, Colour 32, Contrast 44
Servicemenü-Einstellung
Nicht benutzt
Externen VTR am TV-Gerät anschließen.
Testband 6780000 einlegen.
V.TAPE
drücken.
Display-Feld vollständig z.B. mit einem weichen Tuch abdecken, damit der Kontrast
nicht durch Hintergrundlicht verstellt wird.
FOCUS 1, Vertikallinie 2 an rechter Seite einstellen.
FOCUS 2, Horizontallinie 3 von oben einstellen.
Vertikale und horizontale Einstellung mindestens zweimal wiederholen, immer mit
Horizontaleinstellung FOCUS 2. abschließen. Siehe
2.
145V
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK