Ausbau, Deutsch 6.9
Drehfuß
BeoVision Avant 32 DVD vorsichtig auf die Seite legen.
Die 4 Klebebandabdeckungen der Löcher im Boden des Drehfußes entfernen.
Dann so lange am Drehfuß drehen, bis die Schrauben durch die 4 Löcher im Boden
des Drehfußes zugänglich sind.
Zur Demontage des Drehfußes die 4 Schrauben herausschrauben. Das Aluminiumblech
auf dem Drehfuß ist mit Doppelklebeband befestigt.
Serviceposition des Hauptchassis, Modul 999
- Obere Rückwand entfernen (sechs Schrauben).
- Oberes Display abschrauben (zwei Schrauben).
Damit das Gerät bedient werden kann, während das Chassis in Serviceposition
steht, muss das obere Display am Chassis angeschlossen sein.
- Kabelverbindungen zum Chassis aus den Kabelhaltern nehmen.
HINWEIS: Beim Zusammenbau des Geräts müssen die Kabel wieder richtig in ihre
Kabelhalter gesetzt werden.
- Beide Sperrlaschen F herunterdrücken und Chassis bis zur ersten Raste herausziehen.
Chassisrahmen oben an den Punkten L fassen und Chassis nach hinten ziehen.
Siehe
14.
Die beiden PCB-Rahmen auf beiden Chassisseiten können nun heraus- und
auseinander geschwenkt werden.
Innersten PCB-Rahmen auf beiden Seiten an die Haken M in den Hauptrahmen-
öffnungen hängen. Siehe
14A.
- Beim Zusammenbau des Geräts darauf achten, dass alle Kabel in den Kabelhaltern
befestigt werden.
Hierdurch werden mechanische Resonanzen bei hohen Lautstärken vermieden.
Die EHT- und FOCUS-Kabel müssen unter dem Bildröhrenhals verlegt und an den
Kabelhaltern der Entmagnetisierungsspule befestigt werden.
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK