Sostituzione del telaio principale (modulo 999)
- Scollegare la tensione di rete.
- Scaricare il tubo catodico. Vedere l’illustrazione
8.
Per evitare scosse elettriche, scaricare il tubo catodico.
Prima di scaricare il tubo catodico, attendere che siano trascorsi almeno 30 secondi
da quando è stata scollegata l’alimentazione.
- Rimuovere dal tubo catodico il cavo dell’alta tensione, contrassegnato dalla lettera B.
Vedere l’illustrazione
8.
- Rimuovere il PCB32 per accedere ai cavi collegati al PCB14 e al circuito 6IC6.
Scollegare le spine 14P17 e 32P411.
Allentare le due viti, quindi rimuovere il PCB32. Vedere l’illustrazione
10.
- Scollegare le spine in 14P10, 14P11, 14P90, 14P91, 14P20, 14P18, 14P493, 14P492,
14P431 e 14P471. Vedere l’illustrazione
10.
- Scollegare la spina in 2P430. Vedere l’illustrazione
15.
- Scollegare le spine 1010 (per farlo, spingere il piccolo »fermo« verso la spina e
tirare al tempo stesso quest’ultima verso l’esterno) e 1009 sul PCB installato sulla
bobina di deflessione sul tubo catodico. Vedere l’illustrazione
8.
- Rimuovere il cavo di terra dal tubo catodico, contrassegnato con la lettera A.
Vedere l’illustrazione
8.
- Scollegare le spine 9P192 e 3P40. Vedere l’illustrazione
8.
Allentare con cautela il PCB3 dal tubo catodico.
- Scollegare i cavi GND posizionati sotto il coperchio di plastica.
Vedere l’illustrazione
11.
- Disporre il telaio in posizione di servizio.
- Scollegare le spine 2P430, 4P44, 4P45 e 4P46 all’interno del telaio.
Aprire la cornice del telaio, rimuovere il cavo (da 4P46) e il cavo GND dal telaio.
Vedere l’illustrazione
15.
- Chiudere e rimuovere il telaio.
- Trasferire la EEPROM 6IC6 dal vecchio al nuovo telaio.
Rimontare i moduli opzionali sul nuovo telaio. Vedere l’illustrazione
16.
- Inserire il nuovo telaio nel televisore e ricollegare le spine 2P430, 4P44, 4P45 e
4P46 nello stesso. Vedere l’illustrazione
15.
- Chiudere il telaio. Verificare che nessun cavo rimanga bloccato tra il telaio e il
televisore.
- Ricollegare tutti i cavi alle relative spine. Verificare che tutti i cavi siano collegati.
Collegare nuovamente il cavo di terra sul tubo catodico. Montare il PCB3 sul tubo
catodico. Non dimenticare di ricollegare le spine 9P192 e 3P40.
Vedere l’illustrazione
8.
- Eseguire le regolazioni necessarie, come illustrato nella sezione dedicata alle
regolazioni, ovvero:
regolazione della centratura orizzontale, regolazione G2, regolazione del fuoco e
della geometria.
6.24 Scomposizione, Italiano
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK