6.2 Dismantling, English
Dismantling, English 6.3
Service position of Main chassis, module 999
- Remove the upper rear panel (6 screws).
- Unscrew the top display (2 screws).
To be able to operate the product with the chassis in service position, the top display
must be connected to the chassis.
- Take the lead connection to the chassis out of their cable holders.
NOTE: when the product is assembled the leads must be reinstalled correctly in
their cable holders.
- Press down the locking pins F, and pull out the chassis to the first stop.
Grab the chassis frame at the points L at the top, and pull the chassis backwards.
See
14.
The two PCB frames on either side of the chassis can now be tilted out and away
from each other.
Hang the innermost PCB frame on either side on the hooks M in the straps.
See
14A.
- When assembling the product, make sure to fasten all leads in the cable holders.
This will prevent the occurrence of clinking and clanking sounds at high volumes.
The EHT and FOCUS cables must be run below the picture tube throat and tied to
the cable holders on the degauss coil.
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK