5.32 Einstellungen, Deutsch
Einstellungen, Deutsch 5.33
Geometrieprüfung und -einstellung abschließen
Bildröhre und Kontrastfilterscheibe mit Mikrofasertuch reinigen.
Kontrastfilterscheibe einbauen.
Benutzen Sie zur Reinigung der Kontrastfilterscheibe nur das Mikrofasertuch,
Bestellnr. 3375706.
Im Servicemodus unter “Format setting”
Geometry lock
: ON
4:3
: NO
Bildeinstellungen
-
3
im ‘Monitor service menu’ drücken, um Zugang zu den Bildeinstellungen
(Picture adjustments) zu bekommen:
Picture adjustments
1 Rdr XX
Red drive 0 - 63
2 Gdr XX
Green drive 0 - 63
3 Bdr XX
Blue drive 0 - 63
4 Rcu XX
Red cut-off balance 0 - 63
5 Gcu XX
Green cut-off balance 0 - 63
6 Bcu XX
Blue cut-off balance 0 - 63
7 PDL XX
Peak Drive Level 0 - 63
8 Comb filter
9 Movie mode
10 Gain adjust
- ‘Picture adjustments’, d.h. die Bildeinstellungen, sind nur in Format 1/(15:9)
durchzuführen.
- Ein Standard-4:3-Testbild (z.B. Philips) anschließen.
- Bildeinstellung mit den Ziffern (1 - 8) wählen und mit
m
oder
p
einstellen.
Während des Einstellvorgangs ist es möglich, eine neue Bildeinstellung mit
l
oder
n
zu wählen.
Die Einstellung mit
GO
speichern und evtl. eine neue Einstellung wählen, - oder
das Menü mit
STOP
beenden. Zum Verlassen der Service-Menüs die Taste
EXIT
drücken.
Treiber (Drive)
- Helligkeit auf Nominalwert einstellen: Brilliance 32.
- Farbsättigung entfernen: 00.
- Roten und grünen Treiber (‘Rdr’ und ‘Gdr’) auf korrekten Weißton einstellen.
- Bdr darf nur dann verwendet werden, wenn eine korrekte Einstellung mit Rdr und
Gdr nicht erzielt werden kann.
Sperrpunkt-Balance (Cut-off-balance)
- Helligkeit auf Nominalwert einstellen: Brilliance 32.
- Farbsättigung entfernen: 00.
- Rote und grüne ‘Cut-off’-Balance (‘Rcu’ und ‘Gcu’) so lange abgleichen, bis die
dunklen Felder im Testbild farblos sind.
- Bcu darf nur dann verwendet werden, wenn eine korrekte Einstellung mit Rcu und
Gcu nicht erzielt werden kann.
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK