6.16 Démontage, Français
Position d’intervention du châssis principal, module 999
- Déposer le panneau supérieur arrière (6 vis).
- Dévisser l’afficheur supérieur (2 vis).
En position de service, le produit ne fonctionne que si l’afficheur supérieur est
raccordé au châssis.
- Sortir de leurs supports les câbles raccordés au châssis.
REMARQUE : lorsque le produit est assemblé, les câbles doivent être installés
correctement dans leurs supports respectifs.
- Enfoncer les goupilles de blocage F et retirer le châssis jusqu’au premier arrêt.
Saisir le cadre du châssis aux points L (en haut) et tirer le châssis vers l’arrière.
Voir
14.
Il est maintenant possible d’incliner les deux cadres du PCB de part et d’autre du
châssis vers l’extérieur et de les éloigner l’un de l’autre.
Accrocher le cadre PCB intérieur des deux côtés aux crochets M des sangles.
Voir
14A.
- Au moment de l’assemblage du produit, s’assurer de bien fixer tous les câbles
dans leurs supports.
Cela empêchera l’apparition de tintements et de bruits métalliques aux volumes
élevés.
Les câbles EHT et FOCUS doivent être acheminés en-dessous de la gorge du tube
image et attachés aux supports de câble sur la bobine de démagnétisation.
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK