6.18 Démontage, Français
Remplacement de la PCB5 (déviation)
La carte de circuit imprimé (PCB) de déviation et les câbles de connexion sont livrés
sous forme d’un élément unique (réf. 8000919).
NE PAS OUBLIER DE CONNECTER LE CHASSIS AU TAPIS ANTISTATIQUE
Marche à suivre
- Débrancher l’alimentation secteur.
- Décharger le tube image. Voir
8.
Afin d’éviter tout risque d’électrocution, le tube image doit être déchargé.
Attendre au minimum 30 sec après avoir mis hors tension secteur avant de décharger
le tube image.
- Débrancher les câbles de focalisation au niveau de la PCB3.
À l’aide d’un tournevis, appuyer sur le ressort du support « A », puis déposer le
câble.
- Débrancher le câble raccordant la PCB au tube image (1010 et 1009).
- Débrancher l’alimentation haute tension.
- Débrancher les fiches 5P48, 5P49, 5P50, 5P51 et 5P73.
- Déposer la PCB5 et le câble haute tension.
- Mettre en place une PCB5 neuve.
- Brancher les fiches 5P48, 5P49, 5P50, 5P51 et 5P73.
- Raccorder le câble de focalisation statique (NOIR) à la prise A.
- Raccorder le câble de focalisation dynamique (ROUGE) à la prise B.
- Raccorder G2 (rouge) à 3P190.
- Brancher le câble raccordant PCB et tube image (1010 et 1009).
- Brancher le fil haute tension.
A B
1
2
3P190
B
A
FOCUS
1
2
SCR
EEN
5P50
5PS1
5P49
5P48
5P73
5P51
G2
Focus 2
Focus 1
H
1009
1010
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK