Sostituzione del modulo PCB5. Smagnetizzazione
Il PCB per la smagnetizzazione e i cavi di collegamento vengono forniti in una sola
unità (8000919).
TENERE PRESENTE CHE È NECESSARIO CHE IL TELAIO SIA COLLEGATO AL
TAPPETINO DI PROTEZIONE DALLE SCARICHE ELETTROSTATICHE
Procedura
- Scollegare la tensione di rete.
- Scaricare il tubo catodico. Vedere l’illustrazione
8.
Per evitare scosse elettriche, scaricare il tubo catodico.
Prima di scaricare il tubo catodico, attendere che siano trascorsi almeno 30 secondi
da quando è stata scollegata l’alimentazione.
- Scollegare i cavi del fuoco del PCB3.
Usare un cacciavite per spingere la molla nel sostegno A, quindi rimuovere il cavo.
- Scollegare il cavo al PCB nel tubo catodico 1010 e 1009.
- Scollegare l’alta tensione.
- Scollegare le spine 5P48, 5P49, 5P50, 5P51 e 5P73.
- Rimuovere il PCB5 e il cavo dell’alta tensione.
- Inserire il nuovo PCB5.
- Collegare le spine 5P48, 5P49, 5P50, 5P51 e 5P73.
- Collegare il cavo del fuoco statico (NERO) nella presa A.
- Collegare il cavo del fuoco dinamico (ROSSO) nella presa B.
- Collegare il G2 rosso a 3P190.
- Collegare il cavo al PCB nel tubo catodico 1010 e 1009.
- Collegare il cavo dell’alta tensione.
A B
1
2
3P190
B
A
FOCUS
1
2
SCR
EEN
5P50
5PS1
5P49
5P48
5P73
5P51
G2
Focus 2
Focus 1
H
1009
1010
Scomposizione, Italiano 6.25
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK