Bale Band-It GFC 100, Руководство оператора

Страница: 89 / 108

Operator’s Manual 84
085 Waiting for Right Fetcher Out reed switch to be on.
Note: This code occurs when the Reset Bundle button was pressed while the Fetcher
cylinders were extended or partially extended. In order to properly reset, the machine
will fully extend the Fetcher cylinders (unless they are already extended). The machine
will then wait until the Right Fetcher magnet is in front of the Right Fetcher Out reed
switch.
- If the Right Fetcher cylinder is fully extended,
- Check the air gap distance between the Right Fetcher Out reed switch and the
magnet. The distance should be a maximum of 1/8 inch (3 mm). If it is within the
suggested range then the reed switch needs to be replaced.
- If the Right Fetcher cylinder is partially extended,
- Check that a foreign object is not preventing the Right Fetcher cylinder from
extending.
- Electric power or hydraulic power or hydraulic return has been disconnected or
shut off from machine.
- Remove and observe the Fetcher check valve. If the snap ring in the bottom of
the check valve is missing then the check valve needs to be replaced. If you are
unable to push the plunger from the end of the check valve in and it spring back,
then the check valve needs to be replaced.
- If the Right Fetcher cylinder is still retracted,
- Check that hydraulic power is still on to the machine and that return line is still
connected.
- Check that a foreign object is not preventing the Right Fetcher cylinder from
extending.
- Remove and observe the Fetcher check valve. If the snap ring in the bottom of
the check valve is missing then the check valve needs to be replaced. If you are
unable to push the plunger from the end of the check valve in and it spring back,
then the check valve needs to be replaced.
- Check that the directional valve is not stuck.
086 Communication from Band Computer