Bale Band-It GFC 100, Руководство оператора

Страница: 77 / 108

Operator’s Manual 72
- Disengage hydraulic power and unplug main power cord. Wait for approximately 10
seconds, plug back in and engage hydraulic power.
- On Line 3 of Display Monitor, if the number after the dash is 0, then disconnect main
electrical and hydraulic power. Open the plastic computer box in the banding box and
unplug the two 10 amp fuses. Reconnect main electrical power only. Wait
approximately 10 seconds and then reinstall the two 10 amp fuses at the same time.
Recheck number on Line 3 after the dash, it should then be 1. Apply hydraulics.
058 Waiting for Left Fetcher In reed switch to be on.
Note: After the machine has retracted the Right/Left Fetcher cylinder, the Left Fetcher
In reed switch should be lined up with the Left Fetcher magnet, which turns the switch
on. This is what the machine is waiting for.
- If the Left Fetcher cylinder is fully retracted,
- Check the air gap distance between the Left Fetcher In reed switch and the
magnet. The distance should be a maximum of 1/8 inch (3 mm). If it is within the
suggested range then the reed switch needs to be replaced.
- If the Left Fetcher cylinder is partially retracted,
- Check that a foreign object is not preventing the Left Fetcher cylinder from
retracting.
- Electric power or hydraulic power or hydraulic return has been disconnected or
shut off from machine.
- Remove and observe the Fetcher check valve. If the snap ring in the bottom of
the check valve is missing then the check valve needs to be replaced. If you are
unable to push the plunger from the end of the check valve in and it spring back,
then the check valve needs to be replaced.
- If the Left Fetcher cylinder is still extended,
- Check that hydraulic power is still on to the machine and that return line is still
connected.
- Check that a foreign object is not preventing the Left Fetcher cylinder from
retracting.
- Remove and observe the Fetcher check valve. If the snap ring in the bottom of
the check valve is missing then the check valve needs to be replaced. If you are
unable to push the plunger from the end of the check valve in and it spring back,
then the check valve needs to be replaced.
- Check that the directional valve is not stuck.