Bale Band-It GFC 100, Руководство оператора

Страница: 45 / 108

Operator’s Manual 40
- Tap on Vertical Plunger Swing sensor bar switch until display number changes or
replace the sensor bar.
011 Waiting for Vertical Plunger Up sensor bar switch to be on.
Note: After the machine has retracted the Vertical Plunger Swing cylinder, the Vertical
Plunger Up magnet should be lined up with the Vertical Plunger sensor bar switch,
which turns the switch on. This is what the machine is waiting for.
The switch is located
at the top of the sensor bar at the white mark.
If the Vertical Plunger Swing cylinder is fully retracted,
- Check the air gap distance between the Vertical Plunger Up sensor bar switch and the
magnet. The distance should be a maximum of 3/8 inch (9mm). If it is within the
suggested range then the sensor bar needs to be replaced.
If the Vertical Plunger Swing cylinder is partially retracted,
- Check that a bale or foreign object is not preventing the Vertical Plunger Swing
cylinder from retracting.
- Hydraulic power or hydraulic return has been disconnected or shut off from machine.
This circuit has a 2-position valve and cannot be partially extended unless power or
return has been disconnected or shut off.
If the Vertical Plunger Swing cylinder is still extended,
- Check that hydraulic power is still on to the machine and that return line is still
connected.
- Check that a bale or foreign object is not preventing the Vertical Plunger Swing
cylinder from retracting.
- Check that the directional valve is not stuck.