Bale Band-It GFC 100, Руководство оператора

Страница: 93 / 108

Operator’s Manual 88
090 Waiting for Horizontal Plunger reed switch to be on.
Note: This code occurs after the Reset Bundle button has been pressed. After the
machine has extended the Horizontal Plunger cylinder, the Horizontal Plunger reed
switch should be lined up with the Horizontal Plunger magnets, which turns the switch
on. This is what the machine is waiting for.
If the Horizontal Plunger cylinder is fully extended,
- Check the air gap distance between the Horizontal Plunger reed switch and the
magnet. The distance should be a maximum of 3/8 inch (9 mm). If it is within the
suggested range then the reed switch needs to be replaced.
If the Horizontal Plunger cylinder is partially extended,
- Check that a bale or foreign object is not preventing the Horizontal Plunger cylinder
from extending.
- Hydraulic power or hydraulic return has been disconnected or shut off from machine.
This circuit has a 2-position valve and cannot be partially extended unless power or
return has been disconnected or shut off.
If the Horizontal Plunger cylinder is still retracted,
- Check that hydraulic power is still on to the machine and that return line is still
connected.
- Check that a bale or foreign object is not preventing the Horizontal Plunger cylinder
from extending.
- Check that the directional valve is not stuck.