Bale Band-It GFC 100, Руководство оператора

Страница: 15 / 108

Operator’s Manual 10
‰
When attaching hydraulic hoses to tractor, it is very important that the pressure line is
attached to the tractor remote and the tank line is attached directly to the reservoir of the
tractor. The Bale Band-It filters the pressure line right before it enters the first hydraulic
valve manifold. This filter is located between the white Banding Drums. Be certain that the
line coming from this filter (the pressure line) is connected to the tractor remote. Reversing
the pressure line and the return line can cause damage to the machine. The return line DOES
NOT connect to the tractor remote. The return line must connect directly to the reservoir of
the tractor with NO BACK PRESSURE! Back pressure will not allow the Bale Band-It to
work properly. Back pressure is the most common mistake made in hooking up the Bale
Band-It. The return line CANNOT be connected directly to the remote or ran through a
return kit. It must be connected directly to the tank of the tractor or through the fill cap
WITHOUT restriction.
‰
Mount hoses on baler so that while turning corners the hoses are not crimped, cut or
stretched between the tractor and baler and between the baler and Bale Band-It. Also mount
hoses away from any sharp points or edges to prevent cutting or damaging hoses.
‰
Mount the Bale Band-It Monitor in the tractor. When mounting the monitor in the tractor, the
suction cups or stationary bracket can be used. If using suction cups to mount monitor, be
sure to wet both suction cups for secure mounting to glass or similar surface. When
connecting the 12 vdc power to the monitor, the cigarette lighter power adapter or the leaded
cord assembly can be used. If the leaded cord assembly is used, be sure the ‘dashed’ lead is
connected to the positive (+) pole of the 12 vdc supply. If polarity is reversed damage to the
monitor may occur.
‰
Thread strapping into Bale Band-It
o
See “Threading Process”