Axel WOLF 1MS, Руководство пользователя, Страница: 189 / 229

TECHNICAL APPENDIX
| TECHNICAL APPENDIX 189
Tested in SmartScan with the same setup depicted above for ‘normal’ Scan Mode.
If an alarm condition is found on a channel, instead of state an alarm condition, system stops on channel for a period
(depending on tested service that cause alarm condition) collecting more data. In this state no alarm or Trap was
reported. The Channel Memory index reports the cause(s) of the stop (see b
elow: “1 of 3 (CT)”).
If a valid (no alarm) condition is found in this time, system unlocks and normal scan reprises.
If a new alarm condition raises up, system stops again for another observation step.
If no valid condition is found (as in this test case), system unlocks, normal scan reprises and an alarm condition and/or a
trap is reported (corresponding CT field shows a red underlined text: “OFFSET ERROR”):
Note that Channel Memory reports normal index display (“1 of 3”).
If alarm condition persists (as in this test case), after a while the system stops again on channel and the procedure
restarts (note that now the alarm condition status ON persists).