Avid Technology AirSpeed series, Инструкция по установке и эксплуатации

Страница: 228 / 282

8 Maintaining Your AirSpeed Multi Stream
228
7. Press F4.
The Save & Exit Setup dialog box opens.
8. With Yes selected, press Enter to save your configuration settings, and boot the system.
9. When the Restore Menu opens, in the Enter a choice? field, type 2 to recover both the C:
and D: partitions (the entire system disk), and press Enter.
10. Type Y to confirm your changes.
The Symantec Ghost opens. When it is finished, you will get a message in the Recovery
Complete dialog box saying “Drive Image Completed Successfully.”
11. Press and hold the Power button on the front on the AirSpeed Multi Stream to turn it off.
n
If the AirSpeed Multi Stream does not shut off when pressing the Power button, unplug the
power supply to the AirSpeed Multi Stream. Make sure it powers down, and then plug it back
in.
12. Unplug the UFD device from the USB port.
n
If any device, including the UFD, is left plugged in, the drive-lettering script could fail.
13. Re-insert the four media drives into the AirSpeed Multi Stream chassis.
14. Press the Power button again to restore power to the AirSpeed Multi Stream.
the system will begin to startup.
n
If the System Settings Change dialog box opens, it might be because of the USB device that
was plugged in. Click No to close the dialog box.
15. The next step is to set up your system. This is described in the topic “Setting Up Your
System” on page 71 .