Avaya IP Ofice 8.0, Быстрая установка

Страница: 82 / 256

IP Office Basic Edition - Quick Mode Installation Page 82
15-601042 Issue 24i (20 December 2011) IP Office 8.0
5. Initial Configuration Using IP Office Web Manager
This section covers the recommended initial configuration actions for a new system using browser based access to the
system. This covers just the basic configuration, the full range of configuration possible through web based management
is covered in the IP Office Web Based Management manual.
Using IP Office Web Manager
These notes assume that it is a new IP Office system that is being installed. In that scenario, the necessary steps for
supporting IP Office Web Manager are automatically applied to the system. However, for systems being upgraded to IP
Office Release 8.0 or higher, additional steps may be necessary before IP Office Web Manager can be used. See
Enabling
Web Manager .
Initial Configuration Processes
·
!
Warning
The processes marked
(!)
in this list are ones which, if the setting is changed, require the system to be restarted
in order for the new setting to take effect. Changing them may also cause other settings to reset back to default
values. These are additional reasons why these settings should be checked and set as part of initial system
configuration wherever possible.
1. Set the System Mode
(!)
The system can operate in either PBX or Key mode.
2. Set the Country
(!)
The correct country setting sets a range of internal settings, especially relating to the operation of trunks, that
are otherwise not adjustable through the configuration.
3. Set the Default Language
(!)
The system's language for phone displays and voicemail prompts default to the best match to the country
setting. However it should still be checked.
4. Set the Number of Lines
This option is used for Key mode systems. If changed it will overwrite existing button programming.
5. Set the Outside Line Prefix
(!)
This option is used for PBX mode systems. A prefix is not required but 0 or 9 can be used if required.
6. Adding Licenses
The use of and capacity of some features requires licenses added to the configuration.
7. Change the Network Settings
(!)
By default, if connected to a customer network the system requests IP address settings as a DHCP client.
8. Set the Emergency Numbers
The correct emergency numbers for the country must be set to ensure that they are excluded from any
outgoing call restrictions that may be setup later.
9. Select Music on Hold
10. Adjust Automatic Line Selection
For users on a Key mode system, if the user simply goes off-hook to make a call, the system needs to use
automatic line selection to determine which of the user's available line or intercom buttons is used for the call.
83
87
88
89
90
95
91
93
94
95
96