Avaya IP Ofice 8.0, Быстрая установка

Страница: 114 / 256

IP Office Basic Edition - Quick Mode Installation Page 114
15-601042 Issue 24i (20 December 2011) IP Office 8.0
7.6 Changing Components
Except for memory cards (see Memory Card Removal ), cards and external expansions modules must only be removed
and added to an IP Office system when that system is switched off .
In the sections below, the term component can refer to a card fitted into the IP Office or an external expansion module.
Note that for extension ports, by default both an extension entry and a user entry will exist in the IP Office configuration.
Extension entries can be deleted without deleting the corresponding user entry. This allows retention of the user settings
and association of the user with a different extension by changing that extensions Base Extension number to match the
user's Extension ID.
Like for Like Replacement
If replacing with a componenet of the same type no configuration changes are necessary.
1. Switch off the IP Office system .
2. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement must
be installed in the same position.
3. Install the replacement using the appropriate process for the type of component ( Fitting IP500 cards , Adding
External Expansion Modules ).
4. Restart the IP Office system.
Higher Capacity Replacement
If replacing with a component of the same type but higher capacity, when restarted the IP Office will automatically create
configuration entries for the new trunks or extensions/users.
1. Switch off the IP Office system .
2. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement must
be installed in the same position.
3. Install the replacement using the appropriate process for the type of component ( Fitting IP500 cards , Adding
External Expansion Modules ).
4. Restart the IP Office system.
5. Use Manager to configure the new trunks or extensions/users.
Lower Capacity Replacement
If replacing with a component of the same type but lower capacity, after restarting the IP Office the configuration will need
to be edited to remove redundant entries.
1. Switch off the IP Office system .
2. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement must
be installed in the same position.
3. Install the replacement using the appropriate process for the type of component ( Fitting IP500 cards , Adding
External Expansion Modules ).
4. Restart the IP Office system.
5. Use Manager to delete the trunks or extensions/users in the configuration that are no longer supported by the
component installed.
112
110
110
62
72
110
62
72
110
62
72