Avaya IP Ofice 8.0, Быстрая установка

Страница: 115 / 256

IP Office Basic Edition - Quick Mode Installation Page 115
15-601042 Issue 24i (20 December 2011) IP Office 8.0
Additional Processes: Changing Components
Adding a New Component
If adding a new component to an available slot or port, when restarted the IP Office will automatically create configuration
entries for the new trunks or extensions/users.
1. Switch off the IP Office system .
2. Install the replacement using the appropriate process for the type of component ( Fitting IP500 cards , Adding
External Expansion Modules ).
3. Restart the IP Office system.
4. Use Manager to configure the new trunks or extensions/users.
Permanent Removal
If permanently removing the component, the configuration will need to be edited to remove redundant trunk or extension/
user entries.
1. Switch off the IP Office system .
2. Remove the card or external expansion module.
3. Restart the IP Office system.
4. Use Manager to delete the trunks or extensions/users in the configuration that relate to the component removed.
5. In the Control Unit section of the configuration, delete the entry for the component that is no longer present in the
system.
Replacement of a Different Type
If replacing a component with one of a different type, the process should be divided into two stages. First remove the
existing component using the Permanent Removal process above and adjust the configuration and reboot. Then install
the new component using the Adding a New Component process above.
110
62
72
110