Arctic Cat Bearcat 570 2012, Руководство оператора

Страница: 40 / 76

36

NOTE: The snowmobile must be
on a level surface for this procedure.
2. Shut the engine off; then remove the
oil level stick from the oil reservoir.
Wipe the stick clean.
ZJ002A
3. Insert the oil level stick into the oil
reservoir without threading it in and
remove. Read the oil level shown on
the stick. The oil level should be near
the middle of or on the high end of
the NORMAL range on the stick.
0741-490

NOTE: To attain an accurate oil
level reading, do not thread the stick
into the reservoir.
4. If steps 1-3 were followed and the
oil level is at or below the ADD
mark, add up to 1/2 qt of recom-
mended engine oil.

NOTE: Care must be taken not to
over-fill the reservoir with oil.
5. Repeat steps 3-4 until the oil level is
within the recommended range on
the oil level stick.
Changing Engine Oil/
Filter (1100 cc Models)

NOTE: Recycle or properly dis-
pose of the used engine oil.
1. Using a putty knife, remove the
belly pan plug.
2. Park the snowmobile on a level sur-
face; then start the engine and allow
it to warm up for 5-10 minutes, or if
the snowmobile was operated, allow
the engine to idle for approximately
30 seconds.
3. Shut the engine off; then place drain
pans beneath both engine oil drain
plugs (crankcase and oil reservoir).
ZJ003A
4. Remove the drain plugs and allow
the oil to drain completely.

NOTE: At this point, remove the
strainer from the oil reservoir to
allow the oil to drain completely.
5. After the oil has drained completely,
install the oil strainer, drain plugs,
and washers and tighten to 16 ft-lb.

NOTE: Always install a new Oil Pan
Drain Plug Gasket (p/n 3402-011) and
a new Reservoir Drain Plug O-Ring (p/
n 1670-926) when changing the oil.
6. Install a new belly pan plug.
7. Using Oil Filter Wrench (p/n 0644-
389), loosen (but do not remove) the
oil filter and allow the oil to drain
from the filter; then remove the filter.
8. Apply a light coat of fresh engine oil
to the seal of the new oil filter.
9. Install the new oil filter by turning
the oil filter by hand until the seal
has contacted the oil filter mounting
surface; then tighten the oil filter to
15 ft-lb.
10. Pour 2.9 l (3 U.S. qt) of the recom-
mended engine oil into the oil reservoir.
! WARNING
Care must be taken if a hot drain plug
is removed by hand. Burning could
occur.