Arctic Cat Bearcat 570 2012, Руководство оператора

Страница: 22 / 76

18

NOTE: When the snowmobile is
operated in extremely cold weather (-
23° C/-10° F or colder), a small
amount of leakage may be present.
Unless the leakage is excessive,
replacement is not necessary.
Rebuildable Gas

NOTE: The presence of a FOX
identifier (decal or embossed) on a
shock absorber body indicates a
“rebuildable” shock absorber.

NOTE: The frequency of servicing
rebuildable shock absorbers will
vary according to the types of condi-
tions and terrain the snowmobile has
been subjected to. If riding quality
deteriorates (or seems to be deterio-
rating), take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for shock absorber evaluation
and/or servicing. This service is at
the discretion and expense of the
snowmobile owner.
Servicing rebuildable shock absorbers is
considered normal maintenance and is
the responsibility of the owner. Take the
snowmobile to an authorized Arctic Cat
Snowmobile dealer for this service. This
service is at the discretion and expense of
the snowmobile owner. Kits are available
to either stiffen or soften gas shock valv-
ing. If changes in shock valving are
desired, see an authorized Arctic Cat
Snowmobile dealer. This service is at the
discretion and expense of the snowmo-
bile owner.
Each shock absorber should be visibly
checked weekly for fluid leakage, cracks
or breaks in the lower case, or a bent
plunger. If any one of these conditions is
detected, replacement is necessary. Take
the snowmobile to an authorized Arctic
Cat Snowmobile dealer for this service.
If not under warranty, this service is at
the discretion and expense of the snow-
mobile owner.

NOTE: When the snowmobile is
operated in extremely cold weather
(-23° C/-10° F or colder), a small
amount of leakage may be present.
Unless the leakage is excessive, ser-
vicing is not necessary.
Standard-Lug Track
Accelerated wear strip wear caused by
operating on hard-packed snow condi-
tions is NOT covered under Arctic Cat
Inc. warranty policy.
Track Studs

NOTE: Stud or hooker plate installa-
tion will void track and tunnel warranty.

NOTE: Stud installation can be per-
formed by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat Snow-
mobile dealer for this service. This
service is at the discretion and
expense of the snowmobile owner.

NOTE: To prevent tunnel damage
from the studs, Tunnel Protector Kit (p/
n 4639-771) for the Bearcat 570/T570
models or (p/n 5639-143) for the
Bearcat Z1 XT/F570 models must be
installed.
For proper installation, use the following
procedure:
1. Using the appropriate stud template
(see chart), mark the desired stud
pattern to be used.
CAUTION
If installing studs on standard
Bearcat 570 model with a single-ply
track, studs with a head diameter of
at least 28.6 mm (1.125 in.) must be
used.
! WARNING
When installing studs on a single-ply
track, it is important to use Arctic Cat-
approved studs (proper head diame-
ter). If approved studs (proper head
diameter) are not used, studs could
tear free of the track causing possible
injury or even death. Consult an
authorized Arctic Cat Snowmobile
dealer for information.
CAUTION
If installing studs, a short Snowflap
(p/n 5639-232) must be installed or
component damage will occur.