Arctic Cat Bearcat 570 2012, Руководство оператора

Страница: 13 / 76

9
Clock (Electric Start)
With the clock selected on the readout
screen by pushing and holding the right
button for two seconds, the option of
selecting the 12-hour or 24-hour clock is
available. Push the left button for 12-hour
display; push the right button for 24-hour
display. At this point, the hours and min-
utes will begin to flash. Push the left but-
ton to change the hour display; push the
right button to change the minute display
(either tap the buttons for individual num-
ber display or push and hold the buttons
for rapid number display).

NOTE: During clock setting if nei-
ther button (left, right) is pushed
within a 5-second time period, the
clock-setting mode will be exited
with changes saved.
Service Icon
On electric start models, the icon should
illuminate each time the key is turned to
RUN or START, and it should go out when
the engine starts. If the icon stays illumi-
nated (on electric start models) or it illumi-
nates while the engine is running, the
system is receiving input that is outside of
its established parameters. If the icon illu-
minates indicating an error, take the snow-
mobile to an authorized Arctic Cat
Snowmobile dealer for service. If not under
warranty, this service is at the discretion
and expense of the snowmobile owner.
Coolant Temperature
Warning Icon (Bearcat Z1
XT Models/TZ1 Model)

NOTE: When cold-starting the
engine, the coolant temperature
warning icon will illuminate, the read-
out screen will display TEMP, and
engine RPM limit will be below drive
system engagement speed.
When the engine reaches proper operat-
ing temperature, the coolant temperature
warning icon and TEMP display will
cease to flash.
If the coolant temperature rises too far
above proper operating temperature, the
coolant temperature warning icon will
flash a warning (alert) and the engine will
“surge” to alert the operator. If the cool-
ant temperature rises to a critical point
above proper operating temperature, the
coolant temperature warning icon will
cease flashing and will remain constantly
illuminated.

NOTE: If the coolant temperature
icon is constantly on, the engine will
shut off if vehicle speed is reduced
to 1.5 kph (0.9 MPH) or slower.
Charging System Warning
Icon (Bearcat Z1 XT
Models/TZ1 Model)
The Charging System Warning Icon is
designed to warn the operator if the bat-
tery charging system is not functioning.
The icon should illuminate each time the
key is turned to RUN or START, and it
should go out when the engine starts. If
the icon stays illuminated or it illuminates
while the engine is running, the battery is
not being charged, and the snowmobile is
running on battery reserve power only.
If the Charging System Warning Icon
illuminates, you should, as soon as possi-
ble, take the snowmobile to an authorized
Arctic Cat Snowmobile dealer for ser-
vice. If not under warranty, this service is
at the discretion and expense of the
snowmobile owner. The engine WILL
NOT RUN without battery power.
CAUTION
At this point, take precautionary mea-
sures such as changing to loose
snow terrain, shutting the engine off
(allowing the engine to cool down),
and checking coolant level. If unable
to either determine or remedy the
problem, take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for service. If not under war-
ranty, this service is at the discretion
and expense of the snowmobile
owner.