AND Check Weighing Indicator AD-4404, Инструкция по эксплуатации

Страница: 46 / 162

Page 44
7.1. 7.1. 7.1. 7.1. Use of the Code Use of the Code Use of the Code Use of the Code
7.1.1. 7.1.1. 7.1.1. 7.1.1. Recalling a Code Recalling a Code Recalling a Code Recalling a Code
A preset code can be recalled to use it always.
Caution If the code number is changed during operation, the I/O status is changed,
too.
Step 1 Press the CODE RECALL key.
Step 2 Enter code number using the numerical keys. Press the ENTER key to recall it.
Then the I/O status and the display are changed.
7.1.2. 7.1.2. 7.1.2. 7.1.2. Editing a Code in the Sub Editing a Code in the Sub Editing a Code in the Sub Editing a Code in the Sub----display display display display
The setpoints, LoLo, Lo, Target, Hi and HiHi can be edited in the sub-display always.
Refer to
Selection of comparison
[
5q f-2
] for selection of setpoint.
[Function] - [Set function] - [Sequence] - [Basic] - [Selection of comparison]
Preset sub-display form to edit setpoints.
[Function] - [Set function] - [General] - [Sub-display]
Caution If the code number or its parameter is changed during operation, the I/O
status is changed, too.
Step 1 Press and hold the SHIFT key and press the CODE SET key.
Step 2 Enter the setpoint using the numerical keys. Press the ENTER key to store it and
proceed to the next setpoint.
Step 3 Continue step 2 until entering all setpoints.
Step 4 Press the ESC key twice to return to previous mode.