AD-4404 Page
123
10.5.
10.5.
10.5.
10.5.
Remote Operation
Remote Operation
Remote Operation
Remote Operation
This mode can read and write the parameters of the function list, the code data and
calibration data.
The built-in RS-485, RS-422/485 (OP-03) or RS-232C (OP-04) is used for remote
operation.
It is necessary to install the
remote setup program
in the computer or controller
before use. Refer to http://www.aandd.co.jp
Refer to the instruction manual for details of the program.
Caution
Do not download data during a weighing operation.
Do not turn off the indicator during down load.
Remove all connections to prevent an irregular operation.
Maintain the power supply during the remote setup operation.
Entering the Remote Operation Mode
Step 1 Press and hold the
ENTER
key and press the key to display the
menu in a weighing mode.
Step 2 Select the menu
SystemMgmt
using the key,
ENTER
key.
Select
the
menu
RemoteSetup
using the key,
ENTER
key.
Category address: [Function] - [Set function] - [SystemMgmt] - [RemoteSetup]
Step 3 Select a menu using the key,
ENTER
key.
Menu:
Data
or
Software
Step 4 If
Data
is selected, press
Yes
to down load the data using the
key,
ENTER
key.
Step 5 Press the
ESC
key to return to weighing mode.
Advise
The following RS-232C to RS-485 converter can be used.
Содержание Check Weighing Indicator AD-4404
Страница 1: ...Check Weighing Indicator WM PD4000489...
Страница 28: ...Page 26 Blank page...
