Ametek 5100P, Руководство пользователя

Страница: 12 / 83

PN 9000-246-VE, Rev D
Concentration Measurements
After the 5100P Analyzer has been powered up, the Sample gas supply line can
be connected to the optional 5100P Sample Conditioning Panel, or directly
to the 5100P Gas Analyzer, where it begins measuring the Sample gas. For
information on the concentration measurement units for the analyte being
measured, refer to the analyte-specific
Manual Supplement , shipped with the
5100P Analyzer.
About the AMETEK Sample Conditioning Panel
The 5100P Analyzer uses an integrated Sample Conditioning Panel to reduce
the possibility of over-pressurizing the Measuring Cell and to remove unwant-
ed contaminants from the measuring cycle. The 5100P can operate without
this Sample Conditioning Panel in Class I, Division 2 areas.
To maintain ATEX-IECEx certification requirements, do not operate the
5100P Analyzer without the AMETEK-supplied Sample Conditioning
Panel in ATEX-IECEx hazardous locations.
The major components of the integrated sample system and their functions
are illustrated in Figure 1-2 and described in Chapter 2.
Figure 1-2.2.
5100P Sample Panel
component layout (Standard
250 PSIG version shown).
FI
SAMPLE PANEL
TOP VIEW
INLET VALVE
REGULATOR
GENIE FILTER
DRAIN VALVE
FLOWMETER
WITH VALVE
OUTLET FITTING
(TO INSTRUMENT)
GAUGE
MAX PANEL INLET PRESSURE: 250 PSI
INSTRUMENT INLET/PANEL OUTLET: 101 KPA +/- 2.5 KPA
FLOW RATE: 1-2 SLPM
REGULATOR
INLET VALVE
GAUGE
DRAIN
VALVE
GENIE
FILTER
FLOWMETER
WITH VALVE
DRAIN
SAMPLE PANEL
FLOW SCHEMATIC
5100P
ANALYZER
1-2 | 5100P TDLAS Analyzer