21
8.1.2. How to change seed density and tolerance
Enter into Main Menu, selecting “Menu” option from Job Screen. Then, select “Monitor” option and “Seed
Density” finally. Use the up arrows (
or
) or down arrows (
or
) to increase or diminish the value,
respectively. Once the desired value is loaded, select “Back” option to return to Main Menu and select “Exit” to
return to Job Screen, finally.
Pressing the double arrows
and
, the value increases or diminishes in tens. But, the
simple arrows
and
, modify the value in units.
MENU > MONITOR > SEED DENSITY
Figure 11. ConFigureción de la Densidad de siembra (Semillas por metro).
Figure 11. Configuration Menu of the programmed seed density value.
To change this value, select “Seed Tolerance” option from Monitor menu.
MENU > MONITOR > SEED TOLERANCE
8.1.3. How to Enable/Disable Seed Density Monitoring
If you want to disable seed density failure alarms, enter to Main Menu and select the corresponding option in
the “Advanced Options” menu. Follow a same procedure if you want to enable it again:
MENU > MONITOR > SEED DENSITY MONITORING (ENABLED/DISABLED)
This option is useful in case of jet seed of fine crop, where you want to check seed flow and not the number of
sown seeds.
This value, together with TOLERANCE value, will define the range within
density failures are not considered.
Seed Density
Use las flechas para modificar la
ILUMINACIÓN DE FONDO. Seleccione
8.0
S / m
SEED DENSITY RANGE
Use the arrows to modify the SEEDS PER METER value.
Select "Back" to return to Main Menu.
Volver
+
-
+
-
