12
2.5.2. “Chart” Tab
The “Chart” Tab represents the value of the seeds per meter that are being planted per rows and also the seed
and fertilizer sensor status (
Figure 3
).
Figure 3. “Chart” Tab presents immediate value of planted density per row (seeds per meter), and the sensors status
(dirtiness level) installed in every row. On every row can be mounted a seed sensor (seeds), Linear Fertilizer (F.L.) and
Alongside Fertilizer (F.A.).
The Chart tab will display 39 rows as maximum. In case of more than 39 rows are being
monitored, they will be distributed in other pages. To go to a different page press the key
corresponding to the tab Chart as many times as necessary.
Seeds and fertilizers sensors status
Sensor OK, auto-adjust
1
low level
Sensor OK, auto-adjust half level
Sensor OK, auto-adjust high level
Sensor disabled (page. 25)
Sensor disconnected (page 33)
Sensor with wire in short-circuit (page 33)
1
Auto-adjust level. In some occasions a blanket of agrochemical (inoculants, fertilizer, etc.) can be accumulated on
the harvest’s pipes’ walls, and consequently, on the lenses of the seeds and fertilizer sensors. Under those
conditions, the sensors automatically determine the blanket’s thickness and auto-adjust themselves to get an optimum
reading.
2.5.3. “Rate” Tab
The “Rate” Tab displays the rate prescription map if automatic rate mode is being used (
Figure 4
), or it displays
the preprogrammed seeds or fertilizers rate in case that manual rate mode is being used. (
Figure 5
)
Row Dens Sensor status
S/m Seed F.L. F.A.
Row Dens Sensor status
S/m Seed F.L. F.A.
Row Dens Sensor status
S/m Seed F.L. F.A.
M
e
n
u
R
a
te
C
h
ar
t
P
ip
es
Speed
Km/h
8.4
Density 12.0
S/m
12.2
Plot Hectares
Ha
0.2
Plot 1
Fert L 110
Kg/ha
110
Fert A 95
Kg/ha
95
