agrifac Condor C03, Руководство пользователя

Страница: 83 / 250

OPERATION
Condor-UM-2011-21-R0-en-us-20210108
83
5.15 Starting the engine with auxiliary batteries
NOTICE Do not try to start the engine by towing the machine. This will damage the drive
system.
WARNING Use safety goggles and rubber gloves. If any battery acid
gets in your eyes: immediately rinse your eyes with plenty of
water and get medical aid. If any battery acid gets on your
skin: immediately wash your skin with soap and water.
WARNING When there is frost, the electrolyte in a discharged battery can freeze. Do not connect
an auxiliary battery to a frozen battery. The frozen battery can explode.
Use two 12 Volt auxiliary batteries. Use 3 well insulated jumper cables with a wire cross-section of
at least 50 mm
2
. In between the auxiliary batteries and the machine, you need jumper cables with
a length of approximately 15 feet
(5 meters)
.
Condor 5:
1.
Switch electrical components off.
2.
Remove the ignition key from the ignition switch.
Take the ignition key with you.
3.
Turn the key of the battery switch counterclock-
wise [1].
4.
Place the auxiliary batteries [2] next to the ma-
chine (as shown).
5.
Connect the (+) and (–) terminal of the auxiliary
batteries with the jumper cable [4]. These batter-
ies are now connected “in series” and produce 24
Volts.
6.
Remove the cover [5].
7.
Put the clamp [6] on the (+) terminal of the bat-
tery [3] in the machine.
8.
Put the clamp [7] on the (+) terminal of the auxil-
iary battery.
9.
Put the clamp [8] on the (–) terminal of the auxil-
iary battery.
10.
Put the clamp [9] on a bolt on the engine. Do not
put the clamp [9] on a battery terminal: sparks
could ignite an explosive gas escaping from the
battery.
11.
Check that the jumper cables do not contact ro-
tating parts of the engine.
12.
Turn the key of the battery switch clockwise [10].
13.
Start the engine (

82 ).
14.
Remove the clamps in this sequence: [9], [8], [7],
[6] and place the cover [5] back.
15.
Remove the auxiliary batteries.