Agilent Technologies 8960 Series 10, Справочное руководство

Страница: 446 / 614

446
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_status_operation.fm
STATus:OPERation
STATus:OPERation:CALL:GSM Condition Register Bit Assignment
The STATus:OPERation:CALL:GSM register bits will be used to indicate status of processes that occur during
normal GSM call processing operations.
Bit
Number
Binary
Weighting
Condition Description
15 32768 Not Used. Defined by SCPI. This bit will always be 0.
14 16384 Reserved for future use. This bit will always be 0.
13 8192 Reserved for future use. This bit will always be 0.
12 4096 Reserved for future use. This bit will always be 0.
11 2048 Reserved for future use. This bit will always be 0.
10 1024 Reserved for future use. This bit will always be 0.
9 512 Reserved for future use. This bit will always be 0.
8 256 BS Disconnecting This bit will be a 1 when:
• Active Cell mode - the call processing state
reaches (or is in) the idle state
• Test mode - the test set has noted a base station
termination.
7 128 BS Originating This bit will be a 1 when:
• Active Cell mode - the call processing state
leaves the idle state
• Test mode - the test set has noted a base station
origination.
6 64 Call Control Status Changing This bit is set to a 1 when the call control status
change detector has been armed.
5 32 TCH Assignment in Progress This bit will be a 1 when:
• The channel assignment is successfully
completed (when a call is established).
• The test set notes a change in the TCH ARFCN,
cell band, TCH timeslot, or mobile station timing
advance.
• An error message is generated.
4 16 BCH Changing This bit will be a 1 when:
• The downlink signal is transmitting on the new
broadcast channel.
• The test set has noted a change in cell band.
3 8 Call Control Status Alerting This bit will be a 1 when the test set is in the call
alerting state (ringing).