546
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_prog_op.fm
Programming Overview
Programming Overview
Figure 2.
Typical Flow Of Tasks Performed By Control Program
Related Topics
*******************************************************
“Programming a Phase and Frequency Error Measurement” on page 85
“Programming a Transmit Power Measurement” on page 108
“Programming an Output RF Spectrum Measurement” on page 78
“Programming a Power versus Time Measurement” on page 93
“Programming a Fast Bit Error Measurement” on page 72
“Establishing an Active Link with the Mobile Station” on page 28
*******************************************************
Step 4:
Establish Active Link
With Mobile Station
Step 1:
Set Test Set Operating
Mode To Active Cell
Step 2:
Configure Base Station
Emulator (BSE)
Start
Step 3:
Configure Measurement
Execution Parameters
Step 5:
Set Mobile Station
Operating Conditions
Step 6c:
Obtain Set Of
Measurement Results
Step 6b:
Determine
If A Measurement
Is Done
Step 6:
Make
Measurements
Step 6a:
Start Set Of Concurrent
Measurements
Step 7:
Perform
Intra-cell Handover
Step 8:
Disconnect Mobile
Station From BSE
Assign
Mobile Station To
New TCH?
Stop
Yes
No
All Meas
Done
Yes
No
Содержание 8960 Series 10
Страница 26: ...26 Contents ...
Страница 363: ...363 S Hp8960 E1960A GSM Mobile Test Application A 04 Release Reference_Manual Chapters hpib_read fm READ ...
Страница 500: ...500 S Hp8960 E1960A GSM Mobile Test Application A 04 Release Reference_Manual ch_gen_usage fm General Usage ...
Страница 574: ...574 S Hp8960 E1960A GSM Mobile Test Application A 04 Release Reference_Manual ch_error_messages fm Error Messages ...