R3765/67G Series Network Analyzer Operation Manual
7.3 STIMULUS Block
7-8
7.3.2
Interlocking between Channels
Selects whether the measurement condition concerning the signal source is set at the same con-
dition or independently set in each channel when two-channel simultaneous measurement.
(1)
For interlock setting :
The conditions which has been set to the active channel will be automatically set to the oth-
er channel as same.
(2)
For independent setting :
Different measuring condition can be set to channel 1 and 2, respectively.
The setting conditions which can be interlocked between channels are show below:
•
Sweep type
•
Frequency
•
Output level
•
Sweep time
•
Number of measurement point
•
Resolution bandwidth
The Setting and the Explanation
Press the [MENU] to call the signal source menu. (Refer to section A.4.)
Press the {COUPLED CH ON/OFF} to select whether the setting conditions concern-
ing two measurements are set to the same or not.
ON
: Measures channel 1 and channel 2 simultaneously.
OFF
: Measures channel 1 and channel 2 alternately. (Performs the measurement
of channel 1 and them channel 2.)
•
When the sub-measure screen (channel 3 or channel 4) of channel 1 or channel 2
is selected, channel 3 always operates with channel 1 and channel 4 operates
with channel 2.
On the display of the sub-measure screen, the input port can be set in the state of
sub-measure ON.
However, INPUT PORTs can be set independently.
1
2
