ADTRAN Atlas 800 Plus, Руководство пользователя

Страница: 120 / 210

Chapter 10. Dial Plan Terminal Menu
10-8 ATLAS 800
PLUS
User Manual 61200226L1-1
>
GLOBAL
PARAM
Set ATLAS options which apply to all switched operations, both incoming
and outgoing calls.
» End of Number
Timeout
Write security: 3; Read security: 5
This parameter sets the length of time ATLAS will wait before assuming the
outgoing dialed number is complete. The default value is six seconds. This
timeout will only be invoked if the dialed number does not match one of
the patterns set in the Number Complete Template menu.
» Area Code
Write security: 3; Read security: 5
The local area code. This is used for sending caller ID to the Network.
» Nbr Complete
Templates
Write security: 1; Read security: 5
For any outgoing call, ATLAS must be able to recognize when the phone
number is complete. For example, a local number will be seven digits long
while a long distance (1+ #) will be 11 digits long. The ATLAS defaults will
cover almost any installation, and these templates should not require any
additional user input except for unusual circumstances. The template
allows the use of “wildcard” inputs to define numbers:
» Number Type
Templates
Write security: 1; Read security: 5
ISDN interfaces require that a number type be sent over the D channel
when a call is sent or received. A normal RBS trunk does not send a type
designator, but uses prefixes instead. For example, “1 +” prefix is national
long distance call type while a “011 +” prefix would be an international
long distance call type. These templates form a table to permit ATLAS to
translate the RBS prefix into a call type for ISDN and vice- versa.
X = Any single digit
N = Any single digit 2—9
911 = This specific number
[1,2,3...] = A single digit in this group
# Denotes an Entry Number (MAX 50). Press INS/DEL to in-
sert/delete any entry.
Pattern Modifies an entry when you press Enter (MAX 40).
For example, 1+(NXX) NXX - XXXX would be a pattern for a
normal long distance call. Note that the symbols ( ), +, - and
space are not required and are only used to improve read-
ability.
The ATLAS default templates should cover all applications and
should not need to be added to by the user except for very rare
circumstances.