ADTRAN Atlas 800 Plus, Руководство пользователя

Страница: 83 / 210

Chapter 6. Terminal Menu and System Control
61200226L1-1 ATLAS 800
PLUS
User Manual 6-17
»» Load and Use
Config
Write security: 3; Read security: 5
Retrieves the configuration file specified in the
TFTP Server Filename
field
from the server. To start this command, enter
Y
to begin or enter
N
to cancel.
»» Save Config
Remotely
Write security: 3; Read security: 5
Saves the configuration file specified in
TFTP Server Filename
to the
server identified in
TFTP Server IP Address
. To start this command, enter
Y to begin or enter N to cancel.
» System Utilization
Write security: 0; Read security: 0
Displays statistics related to the ATLAS internal operating system. Please
check with ADTRAN Technical Support before attempting to use this
menu.
» System Selftest
Write security: 3; Read security: 5
Initiates a system self-test. The self-test consists of memory tests and data
integrity tests for each installed module.
»» Selftest Run Write security: 3; Read security: 5
Activates the self-test. To confirm self-test activation, press
y
; to cancel the
self-test press
n
.
»» Status Security level: 3; Read security 5
Indicates a system self-test. The self-test consists of memory tests and data
integrity tests for each installed module.
»» View Selftest Log Read security: 5
Displays time-stamped log of the tests conducted and the Pass/Fail results.
Self-tests verify data integrity and processor control to each port. Each port
is looped back and a data pattern is sent and tested.
The result of the self-test on each installed port is listed with Pass/Fail re-
sults. A typical test log is shown in Figure 6-5. The log includes the following
additional fields.
If you execute this command, the ATLAS 800
PLUS
retrieves the
configuration file, reboots, then restarts using the new configuration.
Before using this command, you must have identified a valid TFTP
server in
TFTP Server IP Address
.
Self-tests disrupt data flow.