ADTRAN Atlas 800 Plus, Руководство пользователя

Страница: 75 / 210

Chapter 6. Terminal Menu and System Control
61200226L1-1 ATLAS 800
PLUS
User Manual 6-9
»» Port Type
Write security: 2; Read security: 5
Specifies whether you use
Direct
or
Dial
mode.
»» Port Speed
Write security: 2; Read security: 5
Specifies the baud rate of the port. Select either 2400, 9600, 19200, or 38400.
If you are using
Dial
for Port Type , ensure that the Port Speed setting
matches the modem baud rate.
»» Modem
Initialization String
Write security: 2; Read security: 5
Specifies the initialization string for a modem. Refer to your modem docu-
mentation for acceptable initialization strings.
»» Initialize Modem
Write security: 4; Read security: 5
Sends the Modem Initialization string to the modem. When you select this
command, the following message displays:
Please verify a modem is con-
nected to the chain port before continuing. Confirm (y/n).
Ensure that a
modem is connected before selecting
Y
.
»» Flow Control
Write security: 2; Read security: 5
This option sets the flow control for the chain port. You may configure the
chain port flow control for
OFF or H/W (hardware).
» SNMP
Write security: 3; Read security: 5
Provides a way to configure SNMP access for the ATLAS 800
PLUS
. For
detailed information on SNMP, refer to SNMP Management on page 12-1.
The following options are available for review and editing:
»» SNMP Access
Write security: 3; Read security: 5
Defines whether SNMP access to the ATLAS 800
PLUS
is enabled or disabled.
Select the appropriate option.
»» SNMP Communities
Write security: 3; Read security: 5
Defines SNMP manager(s) characteristics as follows:
»» Trap Transmission Write security: 3; Read security: 5
Enables and disables SNMP trap transmission.
»» Authen Trap
Transmission
Write security: 3; Read security: 5
Enables and disables the authentication failure trap.
IP Address Specifies the IP address of the network manager.
Privileges
Defines Get (read-only) and Get/Set (read and write) privi-
leges.
Get Name Defines the community name for Get access. This value
must match the Get name defined on the network manage-
ment station. Public is the default name.
Set Name
Defines the community name for Set access. This value must
match either the Get or Set name defined on the network
management station. Public is the default name.