ADTRAN Atlas 800 Plus, Руководство пользователя

Страница: 128 / 210

Chapter 10. Dial Plan Terminal Menu
10-16 ATLAS 800
PLUS
User Manual 61200226L1-1
QUAD T1/PRI MODULE (USER TERMINATION/RBS)
When you are working in the User Termination section of the Dial Plan
menu, the Slot is defined as a T1/PRI module, and Sig is set to RBS, the fol-
lowing configuration options are available:
»» First DS0/Number
of DS0s
Write security: 3; Read security: 5
Defines to ATLAS the DS0s which will be used for this end point. These are
the DS0s which will be used by ATLAS to send and receive calls to and from
User equipment (PBX). The incoming calls which will be accepted and the
outgoing calls which will be restricted over these DS0s are set by the Incom-
ing Call Accept and Outgoing Call Reject Numbers discussed earlier.
»» DS0s Available Read security: 5
Indicates which DS0s of the T1 have been defined in this switched end point
(indicated by “! “), in another switched end point (indicated by “s”), or in a
Dedicated Map (indicated by “n”).
»» Signaling Method Write security: 3; Read security: 5
Defines to ATLAS the type of signaling to be used across this trunk. The sig-
naling selected needs to match that being used by the user equipment (PBX).
The available options include E&M Immediate, E&M Wink, Loop Start, and
Ground Start.
»» Direct Inward
Dialing
Write security: 3; Read security: 5
Defines to ATLAS whether DID is being used by the Network. This option
only displays if Direct Inward Dialing (DID) is set to Enabled. If DID is
Enabled, then the following information must be defined:
ATLAS converts signaling types between Network and User
Terminations.
DID Digits
Transferred Write security: 3; Read security: 5
Defines the number of digits sent to ATLAS from the Net-
work if DID is used.
DID Prefix Write security: 3; Read security: 5
Defines to ATLAS the prefix digits which are not received as
a part of the DID number. ATLAS uses the combination of
prefix and DID number to determine the User end point
that should receive the incoming call.
If DID is Disabled, then you must define the trunk number.