Additel ADT761 Series, Руководство пользователя

Страница: 56 / 67

◆
The leak rate should be less than 0.02mbar/s for ADT761-D and 0.2bar/s for ADT761-L and ADT761-M or it is
possible the calibrator has a leak.
◆
The ADT761 can also run an automatic leak test (as shown in Section 3.6.1).
4.4 Instability
If the pressure has been unstable for more than 3 minutes in the CONTROL mode, the calibrator will switch to the
STANDBY mode and check for the following:
◆
Make sure all fittings are tightened (Section 3.4.1).
◆
Investigate the system for any potential leaks.
Table 4 - 2 The criteria leak rate of the calibrator has a leak
ADT761 - LLP
ADT761 - D
ADT761 - L
ADT761 - M
ADT761 - H
ADT761 - LA
ADT761 - MA
ADT761 - HA
ADT761 - BP
- 2 . 5 t o 2 . 5 m bar (- 1 t o 1 i nH
2
O )
- 25 t o 25 m bar (- 10 t o 10 i nH
2
O )
- 0 . 95 t o 2 . 5 b ar (- 13 . 5 t o 35 p si )
- 0 . 95 t o 2 . 5 b ar (- 13 . 5 t o 35 p si )
- 0 . 95 t o 2 . 5 b ar (- 13 . 5 t o 35 p si )
0 . 05 t o 3 . 5 b ar . a ( 1 . 2 t o 50 p si . a )
0 . 1 t o 3 . 5 b ar . a ( 1 . 7 t o 50 p si . a )
0 . 1 t o 3 . 5 b ar . a ( 1 . 7 t o 50 p si . a )
100 to 1200 h Pa
- 25 t o 25 m bar (- 10 t o 10 i nH
2
O )
- 0 . 95 t o 1 b ar (- 13 . 5 t o 15 p si )
0 to 7 b ar ( 0 t o 100 p si )
0 to 25 b ar ( 0 t o 375 p si )
0 to 40 b ar ( 0 t o 600 p si )
0 . 05 t o 8 b ar . a ( 1 . 2 t o 115 psi . a )
0 . 1 t o 26 b ar . a ( 1 . 7 t o 390 p si . a )
0 . 1 t o 41 b ar . a ( 1 . 7 t o 615 p si . a )
N / A
0 . 01
0 . 01
0 . 2
0 . 2
0 . 2
0 . 2
0 . 2
0 . 2
0 . 2
0 . 01
0 . 2
0 . 2
2
2
0 . 2
2
2
N / A
Model
Range Range
Critical leak rate
(mbar/s)
Critical leak rate
(mbar/s)
Pressure Module 1
Pressure Module 2
49