F-9
Migrating from HostRAID to Adaptec Ultra320 SCSI
Disabling HostRAID Support
After installing the HostRAID driver, you must disable HostRAID
support before you can use the standalone SCSI features.
Warning:
Before you disable HostRAID, for RAID 1, you must
break a RAID 1 array. See the following steps for instructions.
For RAID 0, you will loose all your data if you try to disable
HostRAID.
To disable HostRAID, follow these steps:
1
Press Ctrl+A keys simultaneously when the Adaptec BIOS
appears.
2
When your SCSI Card appears, press Enter.
If you are using a dual channel card, select Channel A, then
press Enter.
3
On any channel containing an array, scroll down and select
Configure/View HostRAID Settings
.
4
Select the array by scrolling to it and pressing Enter. This will
display the members of that array.
5
Press the
D
key to delete the selected array. When prompted to
confirm deletion of the array, select Yes.
6
At the Deleting Information window, select None and press
Enter
.
7
When prompted, select Yes to continue.
8
Repeat Steps 4 through 7 if there is another array. You will also
need to delete any spares.
9
Once all the arrays and spares have been deleted, press Esc to
go back to the SCSISelect menu.
10
Use the arrow keys to select Configure/View SCSI Controller
and press Enter.
11
From the Configuration menu, select HostRAID and press
Enter
.
12
From the HostRAID Pop-up menu, select Disabled.
U320 UG.book Page 9 Tuesday, September 23, 2003 1:47 PM
