9-7
Installing the SCSI Driver for Windows NT 4.0
To eliminate the Warning message, you must update the Windows
NT 4.0 software configuration, described as follows:
Removing a Host Adapter in Windows NT 4.0
1
From the Control Panel, double-click the SCSI Adapters icon.
2
Click the Drivers tab.
3
Using the arrow keys select the following driver:
Adaptec Ultra320 Family PCI SCSI Controller (NT 4.0)
4
Click the Remove button.
5
If you are sure you are removing the correct host adapter type,
click Yes.
6
Click Yes to restart the computer and initialize changes. Click
No
to return to the SCSI Adapters window.
Note:
Windows NT 4.0 Setup does not delete the device driver
from your system disk; it only updates Windows NT 4.0
software configuration information so that the device driver
is no longer loaded during system startup.
Swapping a Host Adapter
Swapping an Ultra320 Family host adapter for a non-Ultra320 host
adapter is similar to the procedure for adding a host adapter. The
important distinction is that you make all software configuration
changes while Windows NT 4.0 is running and before you make
the hardware changes.
Note:
If you do not install the driver that comes with the new
host adapter, it may result in a Windows NT 4.0 boot failure.
U320 UG.book Page 7 Tuesday, September 23, 2003 1:47 PM
