E-6
Adaptec Ultra320 SCSI Cards User’s Guide
13
You may be prompted with this warning message:
“The software you are installing for this hardware: Adaptec xxxxx
HostRAID driver has not passed Windows Logo testing...”
Ignore the warning and click Continue Anyway.
14
When the driver is copied on the hard disk drive, click Finish.
15
You will be prompted to restart the computer. Select Yes.
The new HostRAID driver will be displayed under SCSI and
RAID controllers in the Device Manager.
Enabling HostRAID Support
After installing the HostRAID driver, you must enable HostRAID
support before you can use the RAID features. To enable
HostRAID for the boot channel, follow these steps:
1
Press Ctrl+A keys simultaneously when the Adaptec BIOS
appears.
2
Select the channel where your boot drive is connected, then
press Enter.
3
From the Options menu, select Configure/View SCSI
Controller Settings
and press Enter.
4
From the Configuration menu, select HostRAID and press
Enter
.
5
From the HostRAID Pop-up menu, select Enabled.
6
Press Esc, save change, then Exit.
Completing the HostRAID Driver Installation
After you have installed the HostRAID driver and enabled
HostRAID support, you need to complete the installation so that
the Windows operating system can detect the new enabled driver
hardware.
To complete your HostRAID driver installation, follow these steps:
1
Restart Windows XP.
Windows XP will detect the newly enabled HostRAID support
and will prompt you for the HostRAID driver.
U320 UG.book Page 6 Tuesday, September 23, 2003 1:47 PM
