10-12
Adaptec Ultra320 SCSI Cards User’s Guide
[xxxxx0ac] Driver already loaded for all host bus adapters
The driver is already loaded for all the supported adapters in this
system.
[xxxxx0a4] SCSI bus reset by third-party hardware
Hardware such as an array enclosure may have reset the SCSI bus.
This is a normal condition unless you receive additional errors.
[xxxxx0a7] Unable to allocate memory
[xxxxx0a8] Unable to allocate memory
This indicates that there may be a problem with the amount of
memory installed in your system. Verify that your system has at
least the minimum amount of memory required by your operating
system.
[xxxxx0a9] Possible interrupt conflict
This indicates that the adapter IRQ conflicts with the IRQ of
another board installed in your system. Check your hardware
documentation for instructions on setting and changing IRQs.
[xxxxx0c9] Invalid command line parameter
A command line option for the driver is invalid. See
Command Line Options on page 10-5
for valid command line
options.
[xxxxx0ca] Invalid command line syntax
[xxxxx0cb] Invalid command line syntax
[xxxxx0cc] Invalid command line syntax
The command line syntax for the driver is incorrect. See
Load Command Line Options on page 10-5
for entering the correct
syntax.
[xxxxx07c] Unable to allocate memory
[xxxxx07d] Unable to allocate memory
[xxxxx07e] Unable to allocate memory
[xxxxx07f] Unable to allocate memory
This indicates that there may be a problem with the amount of
memory installed in your system. Verify that your system has at
least the minimum amount of memory required by your operating
system.
U320 UG.book Page 12 Tuesday, September 23, 2003 1:47 PM
