12-2
Adaptec Ultra320 SCSI Cards User’s Guide
Installing the Driver When Installing Solaris 9
To install Solaris 9 with an Ultra320 SCSI Host Adapter:
1
Start your installation using one of the following:
■
Solaris 9 Configuration Assistant Diskette
■
Solaris 9 Install CD (for Web Jumpstart Installation)
■
Solaris 9 Software (1 of 2 CDs)
Wait until the Solaris Device Configuration Assistant screen is
displayed, then press F4 to add the driver (
F4_Add Driver
).
2
The Install Supplemental Drivers screen is displayed. If you
booted off of the Configuration Assistant diskette, replace it
with the Adaptec driver disk, otherwise, insert the Adaptec
driver disk into the floppy disk drive and press F2
(
F2_Continue
). (See
Appendix B, Windows Error Messages
for
information on creating driver floppy disks.)
3
On the Select Solaris System Version window, select Solaris OS
2.9
by pressing the Spacebar, then press F2 (
F2_Continue
).
4
On the Loading Supplemental Driver Software window, you
will see a progress bar displaying the status of
adpu320.itu
being
loaded into memory. Then the Continue Supplemental Driver
Installation window is displyed. If you need to install other
drivers, insert them into the floppy disk drive and press F2
(
F2_Continue
); otherwise press F4 (
F4_Done
).
5
The Identified Device Drivers window is displayed. The
adpu320
should be one of the identified drivers. Press F2
(
F2_Continue
). The Solaris Device Configuration Assistant
window will be displayed.
If you booted off the Configuration Assistant diskette, reinsert it
into the floppy disk drive and press F2. Otherwise, just Press F2
(
F2_Continue
). You will see the Scanning Devices window with a
status bar, then the Identified Devices window will be
displayed. Among the identified devices, look for the line
Adaptec SCSI Card 39320A - Ultra320 SCSI
or
Adaptec SCSI Card
39320 - Ultra320 SCSI
. If it is not there, please check that you
have the correct driver and SCSI controller.
U320 UG.book Page 2 Tuesday, September 23, 2003 1:47 PM
