9-3
Installing the SCSI Driver for Windows NT 4.0
8
To add other host adapters that are not part of the Ultra320
Family, press S and repeat from Step 5 for each additional
adapter and insert the appropriate driver disk. The Adaptec
Ultra320 Family host adapters use the same driver; it is not
necessary to install the driver again.
9
Press Enter to continue with the Windows NT 4.0 operating
system setup. Follow the instructions on-screen and in the
Windows NT 4.0 documentation to complete the installation.
Completing a Fresh Windows NT 4.0 Installation From CD
1
Insert the Windows NT 4.0 CD into the CD-ROM drive.
2
Start your system. Press the F6 key when you see the following
message:
Setup is inspecting your computer’s hardware configuration...
If you do not see this message, your system may not be setup to
boot from a CD. You will need to install from floppy disks. See
Completing a Fresh Windows NT 4.0 Installation From Floppy Disk
on page 9-2
3
When prompted, press S to specify an additional device.
4
Press Enter to select Others; insert the Ultra320 disk for
Windows in your floppy disk drive.
5
Using the arrow keys, select the following driver and press
Enter
:
Adaptec Ultra320 Family PCI SCSI Controller (NT4.0)
6
To add other host adapters that are not part of Ultra320 Family,
press S and repeat from Step 4 for each additional adapter and
insert the appropriate driver disk. The Adaptec Ultra320 Family
host adapters use the same driver; it is not necessary to install
the driver again.
7
Press Enter to continue with the Windows NT 4.0 operating
system setup. Follow the instructions on-screen and in the
Windows NT 4.0 documentation to complete the installation.
U320 UG.book Page 3 Tuesday, September 23, 2003 1:47 PM
