9-2
Adaptec Ultra320 SCSI Cards User’s Guide
Installing the Driver When Installing
Windows NT
The
adpu320.sys
driver is not embedded on the Windows NT 4.0
installation disks (or CD) and must be added during Windows NT
4.0 installation.
Note:
Adaptec recommends that you install Windows NT 4.0
onto a hard disk with a primary active FAT 16 partition, 2 GB
or smaller. Once Windows NT 4.0 is installed and configured
properly, you can use the Convert command to convert the
drive to NTFS. This minimizes the number of variables
involved during the installation process and therefore
reduces the possibility of problems.
Note:
In order to add or remove SCSI controllers from
Windows NT you must be logged on as Administrator.
Completing a Fresh Windows NT 4.0 Installation From Floppy
Disk
1
Create a Windows driver disk. For more information, see
Appendix D, Creating Driver Floppy Disks
2
Start your system with the Windows NT 4.0 Boot Disk in the
floppy disk drive.
3
When prompted, insert disk #2 in your floppy disk drive. After
a few moments you will see a blue screen. To setup
Windows NT 4.0 now, press Enter.
4
Press S to skip auto-detection of your SCSI host adapter.
5
Press S again to specify an additional device.
6
Press Enter to select Others; insert the Windows driver disk you
created into your floppy disk drive.
7
Using the arrow keys, select the following driver and press
Enter
:
Adaptec Ultra320 Family PCI SCSI Controller (NT4.0)
U320 UG.book Page 2 Tuesday, September 23, 2003 1:47 PM
