ACO CDNP6ACC, Инструкция пользователя

Страница: 59 / 68

59
Pressing the "#" key at any time exits the program without saving the changes.
Deleting (removing) cards:
When the value "
Adres? " is entered, the display will show " Card
”. Then enter "0"
- to set the unit in the card removal mode. The unit waits for the card sequence
number to be erased (from 1 to 6). After this procedure, the card with that
sequence number will be erased from the module memory. The control panel will
confirm deletion of the card with a triple beep and then the message "
Ready " will
be displayed. The procedure can be aborted with the "#" button. If "0" is entered
instead of the sequence number of the card to be erased (1-6), all cards assigned
to this address will be erased.
It is possible to manage cards (adding, deleting, moving cards to other readers,
making backup copies, etc.) using the “
ACC
” PC program for the CDN - ACC
module. Connect the CDN - ACC module to a PC using the special CDN-USB
cable and download the software free of charge from
www.aco.com.pl .
Time of card entering is limited to about 10s.
It is possible to check the correctness of the card assignment to apartment in the
P8 program.
P21 PROGRAMMING THE NAME MODULE USING 2,6,10NP BUTTONS
M-xNP
This program is used to set the physical address of the uniphone (1-255) to be
called using the 2NP, 6NP or 10NP buttons of the module.
After selecting the P21 program, enter the physical address of the uniphone and
confirm with the "
key " button. " P>> X " will appear on the display screen. Now
press the button of the module to which this address is to be assigned for approx.
10s. Each button is programmed individually. To disable the button (it will not dial
any number), enter "0" as apartment number.
The numbers in the module memory can be set automatically (numbering from
the lower buttons 1, 2, 3, etc.):
- Turn off module's power supply, press simultaneously buttons (counting
from the bottom) 1, 3, 5 and turn on the power.