45
After entering the program, the unit display shows "
Adr
" and the currently set
value. Enter a value from the range 0 to 255 and confirm with the key button.
Depending on the value entered, the panel will perform the appropriate function.
Pressing the "#" key exits the program without saving the changes. Entering:
- "
0
" (factory setting) when the contacts are close will activate the E-lock
(opening time set in P6). For Master units, if a delay is set in P6, the E-lock will
be activated with a delay (bit1 in P16 must be enabled).
-
1
to
255
(uniphone physical address) after closing the contacts will activate the
procedure of calling the uniphone programmed at this address. The set address
may be outside the range set in the P9 program.
For CDNP6 series: if bits 1 and 2 of P16 are enables in
slave
units, the value of
parameter "
Adr
" from
1
to
255
corresponds to the time (in seconds) of E-lock
activation delay.
P13 SETTING ONE OF FOUR RINGTONES
Tones
This program is used to set one of four ringtones for each apartment individually
or for all apartments at the same time. The ringtone is set separately for each unit,
so different ringtones can be set in different units; this way the resident is able to
identify the unit transmitting the call.
Enter the program, wait for "
Numer?
” to be displayed, then enter the number of
the apartment for which the ringtone is to be changed (or enter "
0
" if the change
is to apply to all apartment) and confirm with the "
key
" button. When changing the
settings for an apartment, the display will show the currently set ringtone number,
then another ringtone can be selected by entering a value from 1 to 4 - each time
the value is entered, the signal of the selected ringtone will briefly sound. Confirm
the selected tone with the "
key
" button - "
Ready
" will be displayed and the
ringtone will be stored in the memory.
When changing ringtone for all apartments, "
All
" will be displayed briefly,
followed by "
???
" and then, as above, enter the value from 1 to 4 and confirm it
with the key button. Then the unit will display "
Ready
”; settings are now stored
in unit’s memory.
Pressing the "#" key at any time exits the program without saving the changes.
Содержание CDNP6ACC
Страница 67: ...67 Notes...
Страница 68: ...68 IU0401envJ 2247 62 002 Suchy Las ul Diamentowa 7 tel fax 61 843 93 72 www aco com pl...
