Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 389 / 418

Installation and Operation Manual Appendix E Encapsulation over PSN
ACE-3105, ACE-3205 Ver. 5.2 3BATM Service Encapsulation E-9
Parameter Name Purpose
PPP header Identifies the PPP payload and set to 0x21
to indicate an IP frame. 2 bytes long.
IP header 20 bytes long and contains:
• Source IP of the device, as was learned
by the PPP/IPCP session
•
Destination IP of the remote peer
(configured manually)
• Protocol field of the IP header; can be
either UDP (17) or MPLS in IP (137),
depending on the PW configuration.
UDP header Used only for UDP traffic.
8 bytes long and contains:
• UDP source port – identifies the PW label
of the destination unit
• UDP destination Port – uses TDMoIP
protocol number: 0x85E (2142)
PW Label Used only for MPLS in IP mode.
Manually defined per PW and per direction.
4 bytes long.
Control Word Contains the sequence number and control
bits. Optional for some PW types. 4 bytes
long.
Payload The service data carried on the frame,
depending on the PW type.
E.3 ATM Service Encapsulation
ATM traffic is encapsulated in either the one-to-one or N-to-1 mode.
One-to-One (1:1) ATM PW Encapsulation
In the one-to-one (1:1) ATM PW mapping mode (selectable), one ATM VCC/VPC is
mapped to a single pseudowire link. The following figure illustrates the packet
format in 1:1 mode:
0 0 0 0 Reserved (4 bits)
Sequence number (2 bytes)
M V Reserved PTI C
VCI (2 bytes)
Figure E-12. 1:1 Encapsulation Structure
ATM Control
Cell Header