Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 187 / 418

Installation and Operation Manual Chapter 4 Configuration
ACE-3105, ACE-3205 Ver. 5.2 Configuring for Operation 4-97
Table 4-61. LDP Parameters
Parameter Description Possible Values
LDP ID The LDP identifier to be used in all LDP
sessions established with the unit.
Note:
• The IP address must be identical to one
of the interface IP address or system
address (see
Table 4-56 ).
• Cannot be changed when LDP is enabled.
• If the LDP ID is not yet configured and a
system address is defined, the system
address is automatically displayed by
default, and you only need to save this
setting (press S).
0.0.0.0 –
255.255.255.255
Default: 0.0.0.0
Mode Indicates whether all LDP operations
performed by the unit are enabled or
disabled.
'Enable' can be selected only if an LDP ID
is defined.
Enable
Disable
Default: Enable
Hello timer
(sec) The required interval in seconds between
two consecutive Hello messages. LDP Hello
messages enable LDP nodes to discover one
another and to detect the failure of a
neighbor or of the link to the neighbor.
Hello messages are sent periodically on all
interfaces where LDP is enabled.
Note: The Hello timer cannot be modified
when the LDP mode is enabled.
1–65534
Default: 45
Keep alive timer
(sec) For cases of inactivity, define the time in
seconds after which a Keep Alive message is
sent.
Note: The Keep Alive timer cannot be
modified when the LDP mode is enabled.
1–65534
Default: 40
Interface Access the LDP interface configuration See
Configuring the
LDP Interface
Parameters
below
Targeted peers Access the targeted peers configuration See Setting the LDP
Targeted Peers