Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 199 / 418

Installation and Operation Manual Chapter 4 Configuration
ACE-3105, ACE-3205 Ver. 5.2 Configuring for Operation 4-109
Table 4-70. Pseudowire General Parameters
Parameter Description Possible Values
PW number Displays the PW number as defined in the PW
menu (read-only) See
Table 4-69
PW name Displays the PW name as defined in the PW menu
(read-only) See
Table 4-69
PW type Defines the PW type and the type of data it
carries.
For more information about the different
encapsulation types, refer to
Appendix E
.
ATM VP 1 to 1
ATM VC 1 to 1
ATM VP N to 1
ATM VC N to 1
AAL5-SDU
SAToP
Basic CES PSN
Default: ATM VC N to 1
PW subtype When the PW type is Basic CES PSN, the subtype
indicates whether the PW is used for clock
recovery, clock distribution or data.
Note:
• In order to configure IP multicast clock
distribution, the relevant PW should be
created using an IP multicast peer.
• Clock distribution is not supported for DSL
interfaces
Clock recovery
Clock distribution
Data
PSN type The type of packet-switched network on which
this PW is established. "o" stands for over.
Note:
• UDPoIP is valid only for SAToP and Basic CES
PSN pseudowire types.
•
MPLSoIP cannot be selected when the PW
subtype is clock recovery or clock distribution
• MPLSoGRE cannot be set with a peer that is
routed through a PPPoE router interface.
MPLS
UDPoIP
MPLSoIP
MPLSoGRE
Default: MPLSoIP
Peer number Number of an existing PSN peer device (see
Defining PSN Peers
) to which the current PW is
assigned. The PW terminates on this peer.
Note:
• When the provisioning mode is LDP PW ID (see
below), the peer must be configured as a
targeted peer.
• A peer with a multicast IP address can be set
only for a clock distribution or a clock recovery
PW.
• A peer that is routed through a PPPoE router
interface cannot be set for MPLS over GRE.
1–32