Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 208 / 418

Chapter 4 Configuration Installation and Operation Manual
4-118 Configuring for Operation ACE-3105, ACE-3205 Ver. 5.2
Parameter Description Possible Values
VCI from PSN The virtual channel identifier that is expected from the
PSN on this N:1 PW.
Note:
•
Visible only for the N:1 VC PW type.
• This parameter is automatically set according to
the VPI value (see above). You may assign a
different value as long as it is unique for this PW.
32–65535
In TD Policing Traffic Descriptor number
Note:
• For N:1 the TD setting is applied on all the VCs/VPC
connected to the PW (policing occurs on the PW
level).
• The TD of all the VC’s attached to the same N:1
PW must be the same.
• While the In TD is set to 0, the policing for the
selected ATM channel will be stopped.
• Can be changed dynamically (on-the-fly) as long as
it has the same service category and mode.
0–99999
Default: 0
Out TD Traffic Descriptor number
Note:
•
The traffic descriptor must be created first.
• For N:1 the TD setting is applied on all the VCs/VPC
connected to the PW (shaping occurs on the PW
level).
• The TDs of all VC’s attached to the same N:1 PW
must be identical.
• Can be changed dynamically (on-the-fly) as long as
it has the same service category and mode.
•
TD which is created automatically for CES
connection cannot be used.
1–99999
Default: 1
OD ID number of a previously defined OAM descriptor that
is relevant to this PW. The OAM descriptor type must
be Intermediate. 1–320
Default: 3
• All attachment circuit parameters except TD cannot be changed dynamically
(on-the-fly).
• The Save (S) and Remove (R) menu functions appear on this submenu to allow
addition/removal of any VCC/VPC connected to the N:1 PW.
Note