Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 67 / 418

Installation and Operation Manual Chapter 2 Installation and Setup
ACE-3105, ACE-3205 Ver. 5.2 Connecting to Packet-Switched Networks 2-5
Figure 2-5. ACE-3205 - ADSL2+ Ports
³
To connect the SHDSL interface:
1. Connect standard straight UTP cables to the RJ 45 connector of the Ethernet
port designated SHDSL1 or SHDSL2.
2. Connect the other end of the cable to a DSLAM connected to the PSN.
Figure 2-6. ACE-3105 - SHDSL Ports
Figure 2-7. ACE-3205 - SHDSL Ports
2.6 Connecting to Packet-Switched Networks
Using Fiber Optic Ethernet Interface
If fiber optic interfaces were ordered, there are two empty SFP slots as shown in
Figure 2-9 and Figure 2-10 .
ACE-3105, ACE-3205 includes Class 1 lasers. For your safety:
• Do not look directly into the optical connectors (ATM-155) while the unit is
operating. The laser beams are invisible.
Use of controls or performing procedures other than those specified herein may
result in hazardous radiation exposure.
³
To install the fiber optic Ethernet interface (using SFP modules):
1. Lock the wire latch of each pluggable SFP module by lifting it up until it clicks
into place, as illustrated below.
The SFP you are installing may have a different wire latch or closing mechanism. If
this is the case, refer to its manufacturer instructions. Note
Warning